20d ago (edited) in General discussion
Tips on Spline cage for this Van Quater panel
I created my own RC body last year based on a Toyota FJ40 (see attached), and been following along the new Car Modelling course.
I'm not good at it, but I can get it done eventually. I'm really trying to learn how to do it properly.
The issue I'm having is how to spline cage the front fender of this Van. It's got a few compound & blended curves in it and is deceptively complex.
Nik teaches us to focus on the large panels first and I'm conflicted as to which body lines should be splined. I've got Yellow and Red lines in the attached image. Given the reference image how would you guys arrange the splines?
1
13 comments
Tips on Spline cage for this Van Quater panel
skool.com/ultimate-3d-membership-7140
Make Professional 3D Work in Plasticity & Blender Available for Everyone.
Leaderboard (30-day)
1
+97
2
+93
3
+92
4
+64
5
+56
powered by