Ruined prints · 3D Printing Community

Ruined prints

Ok everyone I could use a little help. I’m needing to print multiple of these. When I print one at a time, they end up being great. When I load 5 or 6 on the tray, the issues happen. Everything goes great until about the last 10% or so of the print and then whole thing pops off like there was never any adhesive on the bottom. I’m using bambu’s glue so I know that shouldn’t be the problem. I’d like to get to the point where I can load the whole tray up and print like 10 plus at a time but not until I get this figured out. Also, I know I could print them on the face (flat surface) but when I do, it changes the texture and look that I’m going for.

Printing with Bambu PLA-CF

7 comments